Suppose spare impellers arrive in sealed bags. The factory report shows that the shaft bore passed, but a service shop measures a different size after the bags have been open on a humid shelf. Agree on the material condition for shipment, inspection and installation. A dimensional result is only comparable when the temperature, conditioning state, measurement method and datum mean the same thing. Tighter dry dimensions do not automatically guarantee the correct fit in service.
Give the dimension a condition as well as a tolerance
Polyamide compounds absorb moisture to differing degrees. Moisture and temperature can affect dimensions and mechanical properties; the effect depends on the grade, fibre content, geometry and direction. An impeller may be supplied in a specified dry condition, conditioned state or other agreed status. Do not call a part “dry” merely because it feels dry on the surface. Ask for the compound identity, expected shipment state, packaging and the conditioning method used to set the drawing tolerances. Record the measurement temperature and how the parts are held.
In service, the same impeller also needs enough clearance and a sound shaft connection. Do not assume that all dimensions change by the same percentage, or that a constrained assembled hub changes like a free sample. If the field procedure installs it immediately after opening, define the permissible exposure window. If it requires conditioning first, use the approved method and verify the stabilized measurement basis. Do not soak or heat spare parts using a schedule borrowed from a different resin.
Make receiving results comparable to the supplier’s report
For illustration, a drawing calls for a bore of 20.00 to 20.06 millimetres at a specified delivery state. A sealed sample measures 20.03 after opening under the agreed procedure. A shelf-exposed sample later measures 20.09. That latter reading cannot be judged against the delivery-state interval without first identifying its condition. It also cannot be assumed acceptable for assembly. Verify the permitted installation-state fit and test the unit if the conditions are uncertain. These figures are a fictional illustration, not a tolerance for a real impeller.
Retain bag and batch identification. At receiving, sample across the agreed lots and check seals or package condition before opening. Document how long samples have been out, ambient conditions, whether they were selected sealed, and the instruments and datum used. If a bag is torn, segregate that group until its status can be established. Compare a newly opened retained sample with one that followed the actual service storage procedure. If results diverge, review material and exposure with the supplier instead of averaging the measurements together.
Write a stock rule a service bench can follow
Label the shipment condition and storage instructions on the approved stock record. Store unopened parts as required, and define when opened stock can return to service inventory. Where risk justifies it, use a small approved installation check or a conditioned witness part to confirm both the mounting fit and operating clearance. Revalidate if the resin, glass content, conditioning or bagging method changes. Inspect cracks, deformation and wear separately; putting the part back in a bag does not restore dimensions or reverse damage.
The service manual, engineering drawing and receiving plan should agree on the state that matters. When the result does not identify a material condition, it can show that something changed but cannot reliably allocate the fault to moulding, storage or installation.
For mixed lots, ask the warehouse to keep a sealed witness part from the same identified batch so the first disputed measurement can be reproduced.
Frequently asked questions
Is a sealed bag enough to prove the impeller is dry?
No. It preserves the state to some degree but cannot prove the state at sealing. Check the documented specification and package integrity.
Should every spare be conditioned before measuring?
Only as specified by the approved method. Receiving and installation can call for different states.
Can a service shop machine a tight spare to fit?
Do not alter the part without engineering approval. Fit, strength, balance and clearance can all change.
