YARDPUMP · Technical Article

Can Two Pump Seal Springs with the Same Free Length Be Swapped?

Two seal springs can share a free length and produce different force in the pump. Compare working height, available travel and the approved assembly.

A service shop has two mechanical seal springs. Both are the same length on the bench and appear to fit the same holder. Can the newer one replace the approved part? Free length is a starting dimension. Compare the force at the installed working height and over the intended travel, plus the spring’s fit, material and retention. Then verify the complete seal. In a spring-loaded seal, the spring helps establish contact at the faces; fluid forces and the seal design also affect running conditions.

Identify the travel the seal really uses

Find the seal arrangement and its working height on the correct assembly drawing. Identify which seats constrain the spring and which moving member can travel as faces wear or the assembly moves within allowed tolerances. Note how the spring is centred, how it fits the holder and whether it has an approved direction or retaining feature. If the seal is supplied as a matched assembly, do not assume its bare spring is a separately serviceable part.

Different wire diameter, active coils, end geometry or material can produce different working stiffness. A load curve can also change near contact between coils or if other parts interfere with movement. Both springs may have the correct height before loading but produce different loads once compressed. With too little required force the expected face contact may not be maintained; with excessive force the face pair could heat or wear faster. The correct load range is a property of the complete design and its pressure balance, not a value to infer from the spare’s look.

Compare forces at defined positions

Ask the qualified component or pump team for the approved force bounds at the nominal working height and at meaningful limits of travel. Use a suitable force fixture with the correct seats and alignment. Record whether the parts are loaded toward compression or unloaded and whether the spring returns to its reference state. Check that the actual working range does not reach a solid or interfering condition. Use an approved procedure for aged or conditioned parts if the service involves repeated loading or exposure that might change the response.

An illustrative comparison assumes two springs are 18 mm free and the same fixture holds them at a 14 mm working height. If their linear effective rates over that interval are 2 and 3 N/mm and each starts uncompressed, the 4 mm compression would give 8 and 12 N respectively. These are spring force examples, not face load requirements, and the actual curve may not be linear. If the installed mechanism has an offset, friction or a second spring, use the real construction rather than that arithmetic.

Sketch the tested force against height. A single point may miss different slopes or loss of usable travel near a limit. Check wire material and condition for the approved liquid and temperature, and review the supplier’s revision and trace. A result from a dry part on a bench cannot approve corrosion resistance or compatibility of the complete seal.

Approve the assembled seal if replacement is allowed

If the original seal supplier does not authorize a loose spring replacement, order the approved assembly. Where the engineer approves a new spring, verify assembly location and motion along with the applicable leakage and wet running conditions. Use qualified service or laboratory staff, isolation and only the approved procedures; do not energize an opened pump to see the faces. Document the exact spring and seal versions and usable range so later orders do not revert to “same free length.”

The decision is whether the part maintains the intended operating travel and face-support conditions in this seal. A dimensional match alone, or a seal that looks seated when unpowered, does not make it an equivalent spare.

Frequently asked questions

Can I rely on the force measured at just one height?

Only if the approved method calls for that and the usable travel has already been validated. For a substitution, do not assume identical behaviour at the ends.

Can shims compensate for a softer spring?

They also alter travel and the forces at other positions. Use them only as specified in a validated assembly.

Does matching wire diameter prove two springs are equivalent?

No. Active coils, geometry, material, processing and the intended assembly are also relevant.