YARDPUMP · Technical Article

How Should Whole-Cycle Pump Efficiency Be Calculated When Head Keeps Changing?

Accumulate hydraulic output and active electrical input over the same interval before comparing pump efficiency at changing water levels.

Suppose a drainage pump starts from a high water level and works at a different flow, head and input power as the source falls. One part of the run is more efficient than another. Can two percentages be averaged to describe the cycle? Accumulate hydraulic energy and electrical energy over the same window, then divide the first by the second. If the buyer cares about waiting periods as well, say whether standby consumption is included. An average of percentages gives equal weight to results that may use very different amounts of energy.

Choose the boundary before measuring

At a working point, hydraulic power is liquid density multiplied by gravitational acceleration, volumetric flow and the total head added within the chosen boundary. Use the actual working head, rather than the published maximum. Measure corresponding active electrical input. Name whether it is measured at the pump supply or another point and whether a controller or other load is included. A buyer interested in useful water delivered must distinguish it from water circulating back through a bypass. That boundary is different from checking all hydraulic output at the pump. Define the purpose and measurement points first.

For short periods that are near steady, multiply each power by its duration and add the energies. When the values change quickly, have qualified personnel record the quantities together with appropriate instruments, units and time alignment. Do not pair an isolated flow peak with a long input average. If a different liquid is involved, check the density and whether measurements and the use itself remain suitable. Record flow direction and investigate whether returned water is being counted as delivery.

Make the energy weights visible

In an illustrative clean-water example, segment A delivers one litre per second at three metres of head, using 200 watts of input for 120 seconds. It supplies approximately 29.4 watts of hydraulic power or 3.53 kilojoules of output, on 24 kilojoules of electric input. Segment B delivers half a litre per second at six metres, using 300 watts for 180 seconds. It supplies about 5.30 kilojoules of hydraulic energy on 54 kilojoules of input. Segment efficiencies are about 14.7 and 9.8 percent. Their simple average is about 12.3 percent, but the cycle's 8.83 kilojoules divided by 78 is about 11.3 percent. The figures are a hypothetical calculation and do not describe a real product.

The less efficient period uses more energy and has greater weight in the result. If the full cycle includes a pause during which electricity is still consumed without hydraulic delivery, including that power increases the denominator. An operating-only efficiency and an all-cycle efficiency can both be useful. They should not be placed in one ranking without identifying the different boundaries. For a purchase comparison, keep the tasks and starting and ending conditions comparable.

Report enough detail to reconstruct the result

Keep a segmented table or synchronized record, the start and end of the window and any change in level or discharge destination. Convert litres per minute and metres of head consistently before calculating power. An implausible result should prompt checks of meter ranges, unit conversions, alignment and net delivery, not a revised interpretation after the fact. If head or flow evidence is missing, report measured electric energy and delivered volume where available. Those can still help a buyer without inventing a hydraulic efficiency.

If the recorders use different clocks, check their offset before the run and flag any gap. Shorten the observation interval when the levels change rapidly. This helps a reviewer see which section needs another test.

Frequently asked questions

Can I multiply working flow by the nameplate maximum head?

No. Use head that corresponds to that operating flow and the measured boundary.

Is energy per delivered litre the same as hydraulic efficiency?

No. It relates electric energy to volume. Hydraulic efficiency compares energies and depends on the head provided.

Should waiting time be included?

It depends on the defined task. Identify standby consumption and report which intervals the result covers.

Related reading